Steps to fix Canon Printer Error Code 5100

The Canon Pixma MX700 multifunction printer contains an LCD display that shows various error codes whenever a software or hardware issue persists. Each error code is tied to a specific type of issue to make the resolving process easier. Error code 5100 describes a physical error either incorrectly seated ink tank or with a paper jam. Troubleshooting the issue or error is a quick process that only requires a few standard troubleshooting measures.

The features of Canon PIXMA IP2770 Error Code 5100

  • On your monitor display is displayed a warning message Error Code 5100.
  • The printer is regular but cannot print.
  • Power light flickering and Light resume.

Errors and causes of ErrorCanon Printer 5100

  • Allus infusion that interrupts the movement of ink to cartridge or infusion hose is too short.
  • There are objects that go into the printer device
  • There is split ink or charge on Cartridge is dirty

Steps to fixCanon PIXMA IP2770 Error Code 5100:

Step 1

Press down and hold the On/Off button, which is located on the operator panel of the printer, for one second. Wait 15 seconds and then click on the button again. Attempt to scan or print a document.

Step 2

Check the paper feed tray on the front end of the Canon MX700 to see if there is any visibly paper stuck inside the printer. Open the cover of the printer by gripping the front edge of the printer and thrilling upwards.

Step 3

Grab the edge of the blocked paper and gently pull towards you to eliminate the paper from the paper feeder. Unplug the USB cable and Canon’s power cable, and switch on the printer.

Step 4

Pull off the cover tab of rear plastic and check if there is any paper jam visible or not. Grab the edge of the paper and gently pull toward you until the paper is eliminated.

Step 5

Push the rear plastic cover tab back into place, and reconnect the USB cable and power cable. Attempt to scan or print another document to see whether the error or issue is resolved or not.

Step 6

Open the cover of the printer and wait for the ink carriage to slide into view. Press the Push button on the front of the first tank ink. Pull the tank out and then push it back into place to make sure whether it is properly seated or not.

Repeat the process with the other three ink tanks, and then close the cover of the printer. Switch off the printer and then again back on the printer.

You will need to contact Canon’s customer service supportfor a replacement or repair if error code 5100 continues to flash on the LCD display after going through the resolving steps.

John Rise is a self-professed security expert; he has been making the people aware of the security threats. His passion is to write about Cyber security, malware, social engineering, Games, internet and new media. He writes for printer support at printer customer support or Canon Printer support.

Leave a Reply

Your email address will not be published. Required fields are marked *